Panasonic SAHT670 SAHT670 User Guide - Page 11
RADIO OPERATIONS, THE RADIO, Preset tuning, Manual tuning
View all Panasonic SAHT670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Radio operations 10HBI The radCioontrol reference guide 3 TUNING 4 MEMORY /TUNE MODE FM MODE SELECTOR VOLUME, DOWN, UP Numbered buttons TUNER/BAND 4CH3 VOLUME - + ( ) ¡ ENTER Manual tuning 1 Press [SELECTOR] to select "FM" or "AM". Each time you press the button: DVD/CD→FM→AM→TV→VCR→AUX ¡ Remote control: Press [TUNER/BAND]. 2 Press [ /TUNE MODE] to select "MANUAL". Each time you press the button: MANUAL ↔ PRESET 3 Press [3 TUNING] or [TUNING 4] to select the frequency of the required station. ¡ Remote control: Press [(] or [)]. TUNED: Displayed when a radio station is tuned. ST: Displayed when a stereo FM broadcast is being received. Press and hold [1 TUNING] or [TUNING 2] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found. 4 Adjust the volume. L If noise is excessive in FM Press [FM MODE] to display "MONO". Press [FM MODE] again to cancel the mode. The mode is also canceled when you change the frequency. L FM frequency settings You can change the FM step. The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated 0.1 MHz steps. 1 Press [TUNER/BAND] to select "FM". 2 Press and hold [SELECTOR] on the main unit. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. Note Any FM/AM frequencies preset in channels will be changed by this procedure. Preset them again. Preset tuning There are two methods of pre-setting stations. Automatic presetting: All the stations the tuner can receive are preset. Manual presetting: You can select the stations to preset and the order they are preset in. Up to 15 stations can be set in each, the FM and AM bands. Automatic presetting Do the following once For each, FM and AM. Tune to the frequency where pre-setting is to begin. Press and hold [ENTER] until the frequency changes. ¡ Main unit: Press and hold [MEMORY]. The tuner presets all the stations it can receive into the channels in ascending order. "SET OK" is displayed when the stations are set. The last station to be set is then played. L "ERROR" is displayed Presetting was unsuccessful. Preset manually. Manual presetting 1 Tune to the station (A see left: "Manual tuning"). 2 Press [ENTER]. 3 While "PGM" is flashing Press the numbered buttons to select a channel. Alternatively, press [2 CH 1] then press [ENTER]. The station occupying a channel is erased if another station is preset in that channel. Selecting channels 1 Press [TUNER/BAND] to select "FM" or "AM". 2 Press the numbered buttons or [4 CH 3] to select the channel. To select a 2-digit number Example: To select channel 12, press [X10] A [1] A [2] 10HBI 10HBI RQT7534 11