Pfaff ClassicStyle 1525 Owner's Manual - Page 16

Winding from the second spool holder, Threading, Don't forget

Get Pfaff ClassicStyle 1525 PDF manuals and user guides View all Pfaff ClassicStyle 1525 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Operate your Pfaff select Winding from the second spool holder Push the second spool holder (7) into its hole and place a spool of thread with the corresponding spool cap on it. A Threading Place the thread into guide A and pull it through opening B to the right under hook C. Wind the thread clockwise a few times around the bobbin. Switch on the main switch. Hold the end of thread Àrmly and press the the foot control. The winding action will stop automatically as soon as the bobbin is full. Cut the thread, push the bobbin to the left and remove it. Don't forget: Turn the handwheel release disk (3) back again. Then turn the handwheel (4) towards you until it snaps into place. TIP: If the machine is already threaded, you can easily wind thread from the second spool holder without having to unthread the machine. 1:6 1:6 B C

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
1:6
1:6
B
A
C
Operate your Pfaff select
Winding from the second spool holder
Push the second spool holder (7) into its
hole and place a spool of thread with the
corresponding spool cap on it.
Threading
Place the thread into guide A and pull
it through opening B to the right under
hook C. Wind the thread clockwise a few
times around the bobbin.
Switch on the main switch.
Hold the end of thread
À
rmly and press
the the foot control. The winding action
will stop automatically as soon as the
bobbin is full. Cut the thread, push the
bobbin to the left and remove it.
Don’t forget:
Turn the handwheel release disk (3)
back again. Then turn the handwheel (4)
towards you until it snaps into place.
TIP:
If the machine is already threaded,
you can easily wind thread from the second
spool holder without having to unthread the
machine.