Pfaff hobbylock 756 Owner's Manual - Page 38
Differential
View all Pfaff hobbylock 756 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
DIFFERENTIAL FEED (with differential feed machine only) * Differential feed is a system which "stretches" or "gathers" the fabric, when amount of feed of front feed dog in relation to the rear feed dog is changed. * The differential feed ratio ranges from 1:0.77 1:2.0. Adjustment is made by means of the dif ferential feed adjusting lever as shown. * Use of differential feed is very effective in overedging stretch fabrics and fabrics cut on the bias. (1) Gathered Overedge (Use regular throat plate) * Gathered overedge is most suited for shirring sleeves, yokes, front and back bodices, skirt hems, etc. in stretch fabrics such as knits and jersey be fore assembling into garment. Feed Control Lever Center Mark To set the differential feed adjusting lever * Open looper cover and loosen differential feed adjusting lever thumb screw. * Slide adjusting lever downward below the center mark, as required, to gather, and tighten the thumb screw. Note: The setting position of the lever will differ de pending on the material being sewn and the amount of feed for shirring. * When differential feed adjusting lever is set to maximum gathering ratio, the stitch length will automatically change to 3mm (7/64inch) if previous setting was higher than setting "3". * Be sure to reset the differential feed adjusting lever to center mark for normal overedge stitching. Tighten Loosen Gather J 36