Pfaff smart 350p Owner's Manual - Page 12

Replacing the light bulb, Cleaning the lint box

Get Pfaff smart 350p PDF manuals and user guides View all Pfaff smart 350p manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

6. When replacing the needle clamp, make sure the needle bar is in its highest position. Insert the needle clamp into the needlebar, rotate and lightly push upward till the pin seats into the needle bar. Tighten the needle clamp screw clockwise with 1.5mm Allen wrench. Note: Replace the clear fabric cover with needle guard and presser height adjusting screw before continuing to use the machine. Replacing the light bulb For safety reasons, unplug main power cord prior to replacing light bulb. 1. Make sure that the light bulb is completely cool before removing it from the machine. 2. Open lamp cover. 3. Remove the light bulb and replace new one with the same type rated, MAX 15W. Groove (inside holder) Cleaning the lint box Slide the flatbed extension to the left to remove it from the machine. Grasp the lint box by the ridged finger grips in the front and back and pull to the left to slide the lint box off the machine. Clean the lint out after each project. An accumulation of lint in the box or under the stitch plate may cause needle breakage. Slide the lint box back into the machine. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
10
Groove
(inside
holder)
6.
When replacing the needle clamp, make
sure the needle bar is in its highest
position. Insert the needle clamp into
the needlebar, rotate and lightly push
upward till the pin seats into the needle
bar. Tighten the needle clamp screw
clockwise with 1.5mm Allen wrench.
Note: Replace the clear fabric cover with needle guard
and presser height adjusting screw before continuing
to use the machine.
Replacing the light bulb
For safety reasons, unplug main power
cord prior to replacing light bulb.
1.
Make sure that the light bulb is
completely cool before removing it from
the machine.
2. Open lamp cover.
3.
Remove the light bulb and replace new
one with the same type rated, MAX 15W.
Cleaning the lint box
Slide the
fl
atbed extension to the left to
remove it from the machine. Grasp the lint
box by the ridged
fi
nger grips in the front
and back and pull to the left to slide the lint
box off the machine.
Clean the lint out after each project.
An accumulation of lint in the box or under
the stitch plate may cause needle breakage.
Slide the lint box back into the machine.