Philips DVP3050V User manual - Page 24

H9820UD_IB_EN_1_0210 2/14/05 11:16 AM Page 24 English 24 Videotape Recording Read and follow the steps below to record a television program onto a videotape. ● Before you begin, make sure the DVD/VCR is in VCR mode. Press VCR so VCR light appears on the front of the DVD/VCR. 1 Turn on the TV and set it to channel 3 or 4 or the Video In channel. If you connected the DVD/VCR to the TV using the supplied audio and video cables, select your TV's Video In channel. Details are on page 12. If you connected the DVD/VCR to the TV using the supplied RF coaxial cable, choose channel 3 (or 4) at the TV. Details are on pages 9-11. 2 Insert a tape with its record tab intact into the cassette compartment of the DVD/VCR. If tape playback begins, press STOP C. 3 Press SPEED until the desired tape speed (SP or SLP) appears briefly on the screen. Details about tape speed are on page 60. 4 Press SKIP ∑/CH K or SKIP w/CH L or the Number buttons to select the TV channel to record. 5 Press RECORD I to start recording. "REC" will appear on the DVD/VCR's display panel. 6 To pause the recording, press PAUSE k once. "REC" will flash. To resume recording, press RECORD I or press PAUSE k again. "REC" will reappear. 7 To stop recording, press STOP C. Recording Prevention Video cassettes have record tabs to ensure that recordings are not accidentally erased. 1 To prevent recording, break off the tab with a screwdriver. 2 To allow recording, cover the hole with clear tape. Remove the tab to prevent recording. Cover the hole to allow recording. 1 Turn on the TV. 2 Insert a tape in the DVD/VCR. STANDBY-ON SEARCH MODE DISPLAY REPEAT REPEAT AUDIO A-B SUBTITLE ZOOM ANGLE SKIP / CH RETURN TITLE CLEAR/RESET SLOW 4 VCR DISC/VCR MENU VCR/TV DVD SYSTEM MENU OK 7 3 4 STOP PLAY PAUSE TIMER SET MARKER RECORD SPEED 1 45 89 2 3 67 0 +10 6 5-6 Helpful Hints • Other recording options are on pages 25-30. • The VCR will record in a preset volume. • Pause will switch to Stop after 5 minutes to protect the VCR and the tape from damage. When a recording is paused, review the pause time remaining with the ■ marks on the screen. Each ■ mark equals 1 minute remaining. During the last minute of paused recording, the ■ mark will flash. • If any menu is on the TV screen, RECORD I on the remote does not function. Press CLEAR/RESET to remove the menu.Then, press RECORD I. Or, use RECORD I on the front of the DVD/VCR.