Pioneer 917V-K Owner's Manual - Page 69
Additional information, Resetting the main unit, Switching the speaker, impedance
View all Pioneer 917V-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
English Deutsch Français Italiano Nederlands Español Additional information 12 SIRIUS radio messages Symptom Antenna Error Check Sirius Tuner Acquiring Signal Subscription Updating Updating Channels Invalid Channel Cause Action Antenna is not properly connected. Check that the antenna cable is attached securely. SIRIUS Connect tuner is not properly connected Check that the 8 pin mini DIN cable and AC Adapter are attached securely. The SIRIUS signal is too weak at the current n/a location. Unit is updating subscription. Wait until the encryption code has been updated. Unit is updating channels. Wait until the encryption code has been updated. Selected channel is not available/does not exist. Select another channel. Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the TONE button, press and hold the STANDBY/ON button for about three seconds. 3 When you see RESET? appear in the display, press ENTER. OK? shows in the display. 4 Press SETUP to confirm. OK appears in the display to indicate that the receiver has been reset to the factory settings. Switching the speaker impedance We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. • With the receiver in standby, press STANDBY/ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings: • SP 6 OHM - Use this setting if your speakers are rated at 6 Ω. • SP 8 OHM - Use this setting if your speakers are rated at 8 Ω or more. 69 En