Pioneer AVHP7800DVD Other Manual - Page 16
Installation - parts
UPC - 012562799179
View all Pioneer AVHP7800DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Note: • Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections are correct and the system works properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. • Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. • Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. • Do not place the display in a position where it will impede the driver's visibility or affect the operation of your vehicle's air bags. • The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot - for instance, near a heater outlet. • If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. (Fig. 9) • Do not mount the hide-away unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. • Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. • If the hide-away unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. • If the hide-away unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. • Follow the instructions below when installing the power supply box. -Keep the power supply box as far away as possible from any antenna cable. -Do not install the power supply box where it might obstruct safe driving. Installing the hide-away unit Mounting with Brackets 30° Fig. 9 • The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifires to radiate freely. (Fig. 10) Tapping screw (4 × 12 mm) Do not close this area. Fig. 10 • When installing make sure you leave ample space (approx. 10 cm) in front of the exhaust fan outlet. • When mounting the hide-away unit, make sure none of the leads are trapped between the hideaway unit and the surrounding metalwork or fittings. Car mat or chassis Bracket Screw (4 × 8 mm) Drill 2 to 2.5 mm diameter holes. Fig. 11 15