Pioneer BDP-09FD Owner's Manual - Page 22

03 For steps 5 to 8, the step to which you should proceed depends on the combination of the Video and Audio settings. 7 Select the output video resolution from the COMPONENT VIDEO output terminals. Use / to select, then press ENTER. 5 Select and set the HDMI High Speed Transmission setting for the HDMI OUT (MAIN) terminal. Use / to select, then press ENTER. Setup Navigator BD PLAYER TOP MENU TOOLS Select the output video resolution at the Component video terminal. HOME MENU ENTER RETURN Setup Navigator BD PLAYER Select the HDMI High Speed Transmission setting for HDMI MAIN. On Off Normally select [On] (Recommended). Select [Off] if the video or audio of HDMI-connected was not output in the test output. When HDMI High Speed Transmission for the HDMI OUT (MAIN) terminal is set to On, use a High Speed HDMI™ cable. The picture and sound may not be output properly if any other HDMI cable (for example a standard HDMI™ cable) or an HDMI cable with built-in equalizer is used. 6 Select and set the HDMI High Speed Transmission setting for the HDMI OUT (SUB) terminal. Use / to select, then press ENTER. TOP MENU TOOLS HOME MENU ENTER RETURN If you select [Source Direct], the output resolution is determined according to the video format of the playing source. For details on the resolution settings, see Switching the output video resolution on page 25. 8 Select the aspect ratio of your TV. Use / to select, then press ENTER. Setup Navigator BD PLAYER Select the screen aspect ratio to match your TV. 9 Check the settings. Select Proceed, then press ENTER. Setup Navigator BD PLAYER Select [Proceed] if you want to start testing your audio and video settings. Proceed Setup Navigator BD PLAYER Select the HDMI High Speed Transmission setting for HDMI SUB. On Off Normally select [On] (Recommended). Select [Off] if the video or audio of HDMI-connected was not output in the test output. When HDMI High Speed Transmission for the HDMI OUT (SUB) terminal is set to On, use a High Speed HDMI™ cable. The picture and sound may not be output properly if any other HDMI cable (for example a standard HDMI™ cable) or an HDMI cable with built-in equalizer is used. 10 Output test tones. Use / to select Yes, then press ENTER. Setup Navigator BD PLAYER The test tone will be output. Reduce the volume to an appropriate level. Yes No The video and/or audio may not be output under certain setup. The setup menu comes back in 30 seconds. Caution • The screen in step 11 and test tones are output simultaneously according to the settings in steps 4 to 8. Lower the volume of the devices connected with the player. 22 En