Pioneer BDP-95FD Owner's Manual - Page 14

02 Changing the output video resolution Use the OUTPUT RESOLUTION button located on both the front panel and the remote control to switch the output video resolution for the HDMI and component video outputs. The table below shows the output settings. Setting HDMI output Component output Video/S-Video output 24p output For smooth presentation of 1080/24p or 720/24p video with an HDMI-equipped display compatible with 1080/24p input, set 24p Direct Out (page 41) on this player to On. This player will output 1080/24p video over HDMI in the following cases: • 1080/24p video: When the output video resolution is set to Auto or Source Direct. • 720/24p video: When the output video resolution is set to Auto. AUTO TV's preferred resolution1,2 TV's preferred resolution3 480/60i Note 480i 480p 720p 1080i 1080p 480/60i 480/60p 720/60p 1080/60i 1080/60p 480/60i 480/60p 720/60p 4,5 1080/60i4,5 480/60i 480/60i 480/60i 480/60i 480/60i 480/60i • Even when 24p Direct Out is set to On, if a TV not compatible with 1080/24p video is connected, the actual frame frequency of the video output will be 60 Hz. • The video output will be interrupted when switching the video output from 1080/24p or 720/24p to other output video resolutions, or when switching to 1080/24p or 720/24p from other output video resolutions. Source Dependent on Direct source1,2 Dependent on source 2,5,6, 480/60i Connecting using an S-Video output 1. Refer to 24p output below for conditions. 2. The video output will be interrupted when switching the video output. 3. For resolutions that cannot be output by component output, video is output in the following resolutions: 480/60i 4. Video output is 480i during copy protected DVD-Video playback. 5. Video output during BD-ROM playback is 480i depending on the disc. 6. The frame frequency for 1080/24p is still 60 Hz. You can use the S-Video output instead of the VIDEO OUT jack to connect this player to your TV (or other equipment). • Use an S-Video cable (not supplied) to connect the S-VIDEO OUT to an S-Video input on your TV, monitor or AV receiver. Line up the small triangle above the jack with the same mark on the plug before plugging in. Note • Depending on your display, some of the settings may result in the picture disappearing. In this case, press OUTPUT RESOLUTION repeatedly until the picture re-appears. • 1080/60p and 1080/24p output is only compatible with HDMI displays. They are not compatible with the component video output. • When output video resolution is set to 720p, 1080i or 1080p, video is output in 16:9 format even if TV Aspect Ratio (page 41) is set to 4:3 (Standard). • If the contours of the displayed subjects look jagged or blurred, try setting the output video resolution to 480i. (If you connected this player to your TV with the HDMI connection and the picture disappears when you switch the output video resolution to 480i, use the component connection with the 480i output video resolution or S-Video, the standard composite connection instead.) • Note that when using a Component Video connection with a TV or other AV component (not using HDMI), 480/60i video may be output in 480/60p. To S-video input TV CONTROL IN IR IN SETTING 2 SETTING 1 IR RECEIVER HDMI OUT LAN(100) VIDEO OUT S Y PB PR COMPONENT VIDEO OUT DIGITAL AUDIO OUT COAXIAL OPTICAL AUDIO OUT (5.1ch) CENTER SURROUND FRONT L AUDIO OUT (2ch) L R R SUB WOOFER 14 En