Pioneer DJM-400 - CDJ-400 Package Operating Instructions - Page 13
Troubleshooting
View all Pioneer DJM-400 - CDJ-400 Package manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
TROUBLESHOOTING TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appliances also in use. If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center. Symptom No power No sound, or sound volume is too low. Sound is distorted. Cross fader doesn't work. Can't perform fader start with CD player. Effects don't work. BPM can't be measured. Measured BPM value is incorrect. The measured BPM value is different from the value published with the CD. Possible Cause ÷ The power cord is not connected. ÷ Input selector switch is set incorrectly. ÷ PHONO/LINE input selector switch is set incorrectly. ÷ Connection cables are connected incorrectly, or connections are loose. ÷ Jacks or plugs are dirty. ÷ Master output level is too high. ÷ Input level is too high. ÷ Cross fader selector switch is set to [THRU]. ÷ The FADER START button is set to OFF. ÷ Rear panel CONTROL jack is not connected to CD player. ÷ Only the rear panel CONTROL jack is connected to the CD player. ÷ Effect channel selector (CH. SELECT) setting is incorrect. ÷ Effect parameter adjust dial (LEVEL/ DEPTH) is set to [MIN]. ÷ Input level is set too high, or too low. ÷ BPM may not be correctly measurable with some tracks. ÷ Some differences may occur due to differences in BPM detection methods. Remedy ÷ Connect to power outlet. ÷ Set input selector to playback component. ÷ Set the PHONO/LINE input selector to the component being played. ÷ Connect correctly. ÷ Clean soiled jacks/plugs before connecting. ÷ Adjust master output level (MASTER LEVEL) dial. ÷ Adjust the TRIM dial so that the input level approaches 0 dB on the channel level indicator. ÷ Correctly set the switch to a setting other than [THRU]. ÷ Set the FADER START button to ON. ÷ Use a control cable to connect the CONTROL jacks of DJM-400 and CD player. ÷ Connect both the CONTROL jacks and CD input connectors. ÷ Correctly select the channel on which you wish to apply effects. ÷ Adjust the effect parameter adjust dial. ÷ Adjust the TRIM dial. ÷ Strike the TAP button to set BPM manually. ÷ No remedy is necessary. Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and then on again. 13