Pioneer HTP-074 Operating Instructions - Page 37

6 Wall-mounting the front and surround speaker system Attaching the brackets • When attaching the speakers to brackets, always use the furnished brackets for wall mounting. • Make sure to tighten the supplied screw as securely as possible when attaching the bracket to the back of the speaker. • Do not attach brackets to center speaker or subwoofer. CAUTION • Use the M5 metric thread screw. Do not use inch thread screw. Before mounting • Remember that the speaker system is heavy and that its weight could cause the wood screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall on which you intend to mount the speakers is strong enough to support them. Do not mount on plywood or soft surface walls. • Mounting screws are not supplied. Use screws suitable for the wall material and support the weight of the speaker. If you are unsure of the qualities and strength of the walls, consult a professional for advice. 5 mm to 7 mm (3/16 in. to 9/32 in.) Mounting screw (not supplied) Screw (supplied) 5 mm (3/16 in.) 10 mm (7/16 in.) Additional information Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down BAND, press and hold ÍSTANDBY/ON for about two seconds. 3 When you see RESET? appear in the display, press AUTO SURROUND/STREAM DIRECT. OK? shows in the display. 4 Press ALC/STANDARD SURR to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. Important • If the Standby Through is not set to OFF, you may not be able to initialize the unit. 2 4 34 Cleaning the unit • Use a polishing cloth or dry cloth to wipe off dust and dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. 37