Poulan 1994-01 User Manual

Poulan 1994-01 Manual

Get Poulan 1994-01 PDF manuals and user guides View all Poulan 1994-01 manuals
Add to My Manuals
Save this manual to your list of manuals

Poulan 1994-01 manual content summary:

  • Poulan 1994-01 | User Manual - Page 1
    IMPORTANT MANUAL Do Not Throw Awa oulan PRO OPERATOR'S MANUAL MODEL: 195 GAS POWERED LINE TRIMMER Always Wear Eye Protection. POULAN PRO ShreveiOrt, Louisiana 71129 A DANGER: Read the Operator's Manual and Follow All Warnings and Safety Instruction& Failure To Do So Can Result in Serious Injury
  • Poulan 1994-01 | User Manual - Page 2
    -2600 -3400 Solid State Spark Advance - Nonadjustable SERIAL NUMBER AND STARTING INSTRUCTIONS STARTER ROPE HANDLE ENGINE SWITCH HANDLEBAR k SHOULDER STRAP CLAMP CARBURETOR: Diaphragm If a spark arrestor is required in your area, contact your Authorized Service Dealer for the correct kit -2-
  • Poulan 1994-01 | User Manual - Page 3
    TOOL CANBEDANGEROUS! This unit can causeserious injury including amputation or blindness to the operator and others. The warnings and safety instructions in this manual must be followed to provide reasonable safety and efficiency in using the unit. The operator is responsible for following the
  • Poulan 1994-01 | User Manual - Page 4
    INSTRUCTIONS....(continued) A OPERATOR SAFETY • Always wear safety eye protection. • Always wear heavy, long pants, long sleeves, • Have all maintenance and service not explained in this manual startingtheengine and lettingit run untilit stops. supported to prevent the blade or trimmer problems
  • Poulan 1994-01 | User Manual - Page 5
    8" Brush Blade • Optional 4 Point, 8" Blade B. UNPACKING INSTRUCTIONS 1. After removing the contents from the carton, check parts against Handlebar with Throttle Trigger Assembly 1 • Shoulder Strap w/Warning 1 • Operator's Manual 1 • Loose Parts Bag 1 LOOSE PARTS BAG CONTENTS: • Hex Wrench
  • Poulan 1994-01 | User Manual - Page 6
    tool is received assembled, repeat all steps in this section to be sure assembly is correct and is adjusted for the operator.) A. PREPARATION This Operator's Manual is designed to help you assemble the tool and to provide its safe operation. It is important that you read the entire
  • Poulan 1994-01 | User Manual - Page 7
    3. THROTTLE HANDLE ASSEMBLY a. Remove the rear screw from the trigger housing. Figure 4 . b. Slide the trigger housing onto the right side of the handlebar. Align screw holes in the trigger housing with the screw hole in the handlebar c. Reinstall the rear screw in the trigger housing. Tighten
  • Poulan 1994-01 | User Manual - Page 8
    e. Insert the four shield screws "C." one at a time through the gear box and shield, then thread them into retention plate "J.". f. Tighten the screws evenly and securely with the 3/16" hex wrench (provided). g. Install the dust cup over the arbor shaft. h. Install blade over arbor shaft, making
  • Poulan 1994-01 | User Manual - Page 9
    to read the fuel safety section on page 4 of this manual before you begin. Use POULAN PRO 2 -cycle engine oil. while in storage. To avoid engine problems, the fuel system should be emptied be added at this time if desired; follow mixing instructions on the label. FUEL MIXTURE CHART 40:1 FuebOil Mix
  • Poulan 1994-01 | User Manual - Page 10
    will turn when the engine starts. • Rest engine and shield on ground; supporting trimmer head off ground. NOTE: Remove and discard the plastic shipping guard on the flooded. Ifthe unit still doesn't start;contact yourAuthorized Service Dealer for assistance. STARTING POSITION STOP ( a- Throttle
  • Poulan 1994-01 | User Manual - Page 11
    INSTRUCTIONS head turns when the engine is at idle speed, refer to the "Trouble Shooting Chart." • To stop engine: • Release the throttle trigger. • SAFETY 1. OPERATOR SAFETY a. Always wear eye protection when operating, servicing, or performing maintenance on your unit. See "Safety Accessories."
  • Poulan 1994-01 | User Manual - Page 12
    Carburetor Adjustments." f. Make carburetor adjustments with the drive shaft housing supported to prevent the trimmer line from contacting any object. g. Keep when engine is running. h. Use only for jobs explained in this manual. B. TRIMMER LINE ADVANCE A WARNING • The trimmer line will a
  • Poulan 1994-01 | User Manual - Page 13
    • The line will easily remove grass and weeds from around walls, fences, trees and flower beds, but it also can cut the tender bark of trees or shrubs and scar fences. To help avoid damage especially to delicate vegetation or trees with tender bark, shorten line to 4-5 inches and use at less than
  • Poulan 1994-01 | User Manual - Page 14
    . Time the Tap Button is Pressed. Tap Button 1/8" of Line Throu Figure 19 Wrap Line On Spool As Shown By Arrow Inner Rim Figure 20 3. Trouble Shooting the Trimmer Head and Line NOTE; For best results, POULAN/WEED EATER recommends the use of POULAN PRO brand line. • Does not advance, or
  • Poulan 1994-01 | User Manual - Page 15
    before using this unit! Restrict the use of this power tool to persons who read, understand, and follow the warnings and instructions in this manual and on the unit. ADANGER - BLADE THRUST Whenthespin- ning blade contacts anything it does not cut, a dan- gerous reaction can occurcausingtheentire
  • Poulan 1994-01 | User Manual - Page 16
    Trouble Shooting Chart." e. Make carburetor adjustments with the drive shaft housing supported support. f. Keep others awaywhen riftingcarburetor adjustments. g. Have all maintenance and service not explained in this manual performed by an Authorized Service warnings and safety instructions in this
  • Poulan 1994-01 | User Manual - Page 17
    shoulder strap and keep a firm grip on the unit with both hands. A properly adjusted shoulder strap will support the weight of the unit, freeing your arms and hands to control and guide the cutting motion. b. Keep feet comfortably spread apart and braced for the possibility of a sudden, rapid thrust
  • Poulan 1994-01 | User Manual - Page 18
    . 3. Disconnect the spark plug before performing maintenance except for carburetor adjustments. 4. Make carburetor adjustments with the lower end supported to prevent the trimmer line from contacting any object. 5. Keep others away when making carburetor adjustments. 6. Besure blade ortrimmerhead
  • Poulan 1994-01 | User Manual - Page 19
    instructions, let your Authorized Service Dealer perform these adjustments. A DANGER Make carburetor adjustments with the lower end supported 2 seconds. See "Deceleration Check" - Engine will not run. See "Trouble Shooting Chart." Then, if the carburetor requires adjustment, begin with "Basic
  • Poulan 1994-01 | User Manual - Page 20
    while making high speed adjustments as damage to the engine can occur. 1. Support the lower end so the trimmer line is off the ground and will not operate according to these instructions after repeating the adjusting steps, do not use the unit. Take it to your Authorized Service Dealer. High Speed
  • Poulan 1994-01 | User Manual - Page 21
    11.Remove the rope retainer screw. Figure 28 . Remove any remaining rope from around the pulley ratchet. Figure 29 . 12.Hold pulley housing as shown in Figure 29 (inset). Hand turn pulley clockwise as far as it will go. 13.Turn pulley counterclockwise until the pulley notch is aligned with the
  • Poulan 1994-01 | User Manual - Page 22
    E BLADE SHARPENING A WARNING Always stop the engine before sharpening a blade. The blade will continue to spin after the engine stops or after the throttle trigger has been released. Make sure the blade has stopped coasting and disconnect spark plug before performing work on the blade. 1. Check
  • Poulan 1994-01 | User Manual - Page 23
    TROUBLE SHOOTING REMEDY 1. Fill tank with correct fuel mixture 2. See "Starting Instructions." 3. Install new plug/check ignition system. 4. Clean fuel See "Carburetor Adjustments." 4. Contact your Authorized Service Dealer. 5. Contact your Authorized Service Dealer. 1. Clean or replace air filter.
  • Poulan 1994-01 | User Manual - Page 24
    to rigid quality standards. As with all mechanical products, making adjustments or replacing parts may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer/place of purchase. 2. Consult the yellow pages of your phone directory for the name of the
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
IMPORTANT
MANUAL
Do
Not
Throw
Awa
oulan
PRO
OPERATOR'S
MANUAL
MODEL:
195
GAS
POWERED
LINE
TRIMMER
Always
Wear
Eye
Protection.
POULAN
PRO
ShreveiOrt,
Louisiana
71129
A
DANGER:
Read
the
Operator's
Manual
and
Follow
All
Warnings
and
Safety
Instruction&
Failure
To
Do
So
Can
Result
in
Serious
Injury