ProForm 1010 Zlt Treadmill Uk Manual - Page 13

12. F irmly tighten the four 5/16" x 1" Flat Head Screws (3) and the two 5/16" x 1" Bolts (4) (only one side is shown). With the help of a second person, hold the console assembly near the Right Handrail (83) and the Left Handrail (not shown). Connect the Upright Wire (87) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the wire tie from the Upright Wire. Connect the two ground wires from the console assembly to the two Console Ground Wires (52). 12 Console Assembly Ground Wire Console Wire 52 87 Wire Tie 3 4 Console Wire 87 83 13. S et the console assembly on the Left and Right Handrails (82, 83). Be careful not to pinch any wires. Attach the console assembly to the Crossbar (107) with six #8 x 3/4" Screws (1). Start all six Screws, and then tighten them. Attach the two Console Clamps (105) to the console assembly with four #8 x 1" Screws (53). 13 Console Assembly 105 53 107 1 1 83 82 1 13