ProForm 1010 Zlt Treadmill Uk Manual - Page 14

14. Hold the Right Upright Cover (86) against the console assembly. Align the holes in the Right Upright Cover with the holes in the Right Upright (85). Attach the Right Upright Cover with two #8 x 3/4" Screws (1). Attach the Left Upright Cover (80) to the Left Upright (84) in the same way. Slide the Handrail Caps (81) down against the Uprights (84, 85)  See steps 5 and 7. Tighten the four 3/8" x 4" Screws (7) and the two 3/8" x 1 1/2" Screws (14). 14 Console Assembly 86 1 85 81 80 1 84 81 15. Raise the Frame (55) to the position shown. Have a second person hold the Frame until this step is completed. Orient the Storage Latch (51) so that the large barrel and the latch knob are in the positions shown. Attach the Latch Bracket (6) and the Storage Latch (51) to the Base (95) with two 3/8" x 2" Bolts (8) and two 3/8" Nuts (10). Attach the upper end of the Storage Latch (51) to the Frame (55) with a 3/8" x 2" Bolt (8) and a 3/8" Nut (10). Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 25). 15 55 10 8 Latch Knob 51 Large Barrel 6 95 10 8 16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 27 and 28). 14