ProForm 380 P Treadmill Uk Manual - Page 8
Make sure that the Upright
View all ProForm 380 P Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4. Hold the Console Base (47) near the Left Handrail (71). 4 Attach the ends of the ground wires on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75). Ground Wires 47 Small Hole 75 71 5. Touch the Right Handrail (72) to discharge any static. Slide the sleeve off the connector on the Upright Wire 5 (42) as shown in the inset drawing. Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connec- 72 tor and then insert it. Then, slide the sleeve back over the connector. 42 47 Sleeve Connector 42 6. Set the Console Base (47) on the Right Handrail (72) and the Left Handrail (71). Attach the Console Base with four 3/4" Screws (2). Start all four Screws before tightening them; do not overtighten the Screws. See the lower drawing. Make sure that the Upright Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot between the square post (B) and the Console Base (47). 6 72 2 47 71 2 A B 42 47 8