ProForm 645 Treadmill English Manual - Page 6
Assembly - console
View all ProForm 645 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex key and your own phillips screwdriver . Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. 3/4" Screw (23)-6 1" Tek Screw (77)-4 1 1/4" Tek Screw (108)-2 Cover Screw (52)-4 3/8" Star Washer (83)-4 Pulse Bar Star Washer (65)-4 Endcap Screw Silver Pulse Bar (79)-2 Screw (64)-4 Console Screw (67)-4 2 3/4" Upright Bolt (85)-2 1" Upright Bolt (84)-2 1 1/4" Bolt (63)-4 1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (26) so that the treadmill is more stable. Do not fully fold the Frame until the treadmill is completely assembled. Identify the Right Upright (76) which has a RIGHT sticker. Hold the Right Upright near the Base (81). Insert the Upright Wire (75) into the Right Upright until the Upright Wire is extending from the upper end of the Right Upright. Note: Make sure that the Upright Wire is extending from the side of the post as shown in the inset drawing. Remove the tie from the Upright Wire. Thread a 2 3/4" Upright Bolt (85) and a 1" Upright Bolt (84) with 3/8" Star Washers (83) into the Base (81) and the bottom of the Right Upright (76). Do not tighten the Upright Bolts yet. 6 76 75 Post Wire 76 81 85 26 83 84