ProForm 695e English Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the following tools: the included allen wrench, your phillips screwdriver , adjustable wrench , rubber mallet , and pliers . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M10 Nylon Locknut (26)Ð7 M8 Nylon M8 Split Spacer Locknut (80)Ð2 Washer (58)Ð2 (44)Ð4 M8 Washer (81)Ð6 M8 x 108mm Bolt (79)Ð2 Nylon Washer (11)Ð2 M10 x105mm Carriage Bolt (27)Ð2 M10 Split Washer (93)Ð4 Axle Screw (30)Ð2 M10 x 85mm Bolt (25)Ð1 M4 x 16mm M4 x 16mm Console Plate Flange Screw Screw (35)Ð9 Screw (92)Ð4 (43)Ñ6 1. Hold the Rear Stabilizer (65) against the saddle on the rear of the Frame (1). Make sure that the Stabilizer is 1 26 turned so the square holes are facing away from the Frame. Attach the Stabilizer with two M10 x 105mm Carriage Bolts (27) and two M10 Nylon Locknuts (26). 26 1 2. Turn the Resistance Control (57) counterclockwise to 2 the minimum setting. If the Resistance Control (57) is attached to the Upright (2), remove the M4 x 16mm Screw (35). Pull the bottom of the Resistance Control away from the Upright and then slide it down to remove it. 5 65 27 Tab 57 2 35