ProForm 8.0 Zt Treadmill English Manual - Page 11
Be Damaged When The Power Is
View all ProForm 8.0 Zt Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11. Have a second person hold the console assembly near the Right Upright (89). Connect the Upright Wire (88) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Remove the long tie from the Upright Wire and the tie from the console wire. Then, insert the connectors into the Right Upright (89). Set the console assembly on the Right Upright (89) and the Left Upright (not shown). Make sure that no wires are pinched. 11 Console Assembly Console 88 Console Wire Wire Long Tie 89 88 12. Start an M8 x 25mm Patch Bolt (5) and two 5/16" x 5/8" Patch Bolts (113) with two M8 Star Washers (10) into the Right Upright (89) and Right Handrail (101) as shown. Do not tighten the Patch Bolts yet. Attach the Left Handrail (not shown) as described above. Then, firmly tighten all six Patch Bolts. 12 101 5 113 10 89 11