ProForm C 630 Elliptical English Manual - Page 7

7. Apply a generous amount of the included grease to the Pivot Axle (59) and to the two M8.5 Washers (55). Next, 7 insert the Pivot Axle into the Upright (2) and center it. Reapply grease to both ends of the Pivot Axle. Slide a Handlebar Spacer (47) onto the short tube on each Handlebar (6, 8), and rotate the Handlebar Spacers so the small arrows are pointing toward the floor. Next, slide the Handlebars onto the Pivot Axle (59). Make sure that the Handlebars are on the correct sides. Tighten an M8 x 25mm Button Screw (56) with an M8.5 Washer (55) and a Wave Washer (29) into each end of the Pivot Axle (59). Next, orient the two Handlebar Caps (46) as shown, and press the small tabs on the Handlebar Caps into the two Handlebar Spacers (47). Grease 6 55 29 56 46 59 47 Arrow 2 8 46 47 8. Find the Left Pedal (13), which is marked with an "L." Attach the Left Pedal to the Left Pedal Arm (11) with 8 two M8 x 52mm Button Screws (36), two M8 Split Washers (44), and two M8 Washers (68) as shown. Attach the Right Pedal to the Right Pedal Arm (not shown) in the same way. 13 11 68 68 44 44 36 9. Apply a generous amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) onto the axle, and attach it with an M10 x 27mm Button Screw (66) and an M10 Washer (35). Insert the left Handlebar Arm (5) into the bracket on the end of the Left Pedal Arm (11), and attach it with a Pedal Arm Bolt Set (40). Attach the right Pedal Arm (not shown) in the same way. See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Arms (5). See step 5. Tighten the two M10 x 76mm Button Bolts (27) in the Upright (2). 9 5 40 11 Grease 16 66 35 10. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical trainer to protect the floor or carpet from damage. 7