ProForm Ergo Strider 3.0 Elliptical English Manual - Page 11

11. Identify an Inner Pivot Cover (19). Orient the Inner Pivot Cover and the right Upper Body Leg 11 (6) as shown. Slide the Inner Pivot Cover (19) and the right Upper Body Leg (6) onto the right axle on the Upright (2). Attach the right Upper Body Leg (6) to the axle with an M6 x 16mm Patch Screw (80) and an M6 x 25mm x 1.5mm Washer (33). Identify and orient an Outer Pivot Cover (16) as 2 shown. Then, slide the Outer Pivot Cover onto the outer side of the right Upper Body Leg (6). Attach the Inner and Outer Pivot Covers (19, 16) with two M4 x 16mm Screws (84). Repeat this step for the left side of the elliptical exerciser. 19 33 84 6 80 16 12. Apply a small amount of grease to the barrel of an M6 x 71.5mm Shoulder Bolt (31). 12 Have another person hold the right Pedal Arm (14) inside the bracket on the right Upper Body Leg (6). 35 Attach the right Pedal Arm (14) to the right Upper Body Leg (6) with the M6 x 71.5mm Shoulder Bolt (31), an M6 x 16mm x 1.5mm Washer (36), and an M6 Locknut (77). Identify the Right Outer Leg Cover (20) and the Right Inner Leg Cover (21), which are marked with "Right" stickers, and orient them as shown. Attach the Right Outer Leg Cover (20) and the Right Inner Leg Cover (21) around the right Upper Body Leg (6) with three M4 x 12mm Screws (35). Repeat this step for the left side of the elliptical exerciser. 21 6 Grease 77 36 20 14 31 13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11