ProForm Ergo Strider 3.0 Elliptical English Manual - Page 7

3. Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the Wire Harness (49). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside the Upright, secure the Wire Harness with a rubber band. Slide the Upright (2) onto the Frame (1). Tip: Avoid pinching the Wire Harness (49). Attach the Upright (2) with four M10 x 20mm Patch Screws (79) and four M10 Bright Split Washers (78). Tip: Start all four Patch Screws before tightening any of them. 3 Wire Tie 2 79 78 79 78 49 1 Avoid pinching the Wire Harness (49) 78 79 4. Tip: Avoid pinching the Wire Harness (49) during this step. 4 Orient the Water Bottle Holder (5) as shown and slide it onto the Upright (2). Attach the Water Bottle Holder with two M4 x 32mm Screws (95). Slide the Console Cover (32) onto the Upright (2) and move it downward to the Water Bottle Holder (5). Then, insert the Console Bracket (3) into the top of the Upright. Attach the Console Bracket with four M4 x 12mm Screws (35). 3 32 49 35 2 5 Avoid pinching the Wire Harness (49) 35 95 7