ProForm Space Saver 500 Treadmill English Manual - Page 19
Maintenance And Troubleshooting
View all ProForm Space Saver 500 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 12 on page 11 for replacement instructions. HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 5 on page 16. HOW TO ELIMINATE FLEXING IN THE CENTER OF THE ELLIPTICAL EXERCISER Next, locate the Reed Switch (50). 40 Turn the Pulley (40) until a Magnet (55) is aligned with 50 the Reed Switch. Loosen, but do not remove, the indi- 55 103 cated M4 x 16mm Screw (103). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Rock the Pulley forward and backward just enough that the Magnet passes the Reed Switch repeatedly. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shields, the crank arms, and the link arms. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24. HOW TO ADJUST THE BELT If the elliptical exerciser flexes in the center during use, turn the base foot until the flexing is eliminated. Base Foot If you can feel the pedals slip while you are pedaling, even when the resistance of the pedals is at the highest setting, the Belt (51) may need to be adjusted. First, see step 11 on page 10 and remove the link arms. Next, see step 4 on page 7 and remove the crank arms. HOW TO LEVEL THE ELLIPTICAL EXERCISER Then, remove all the screws from both side shields; there are three sizes of screws in the side shields-note which size of screw you remove from each hole. Then, gently pry the side shields away from the frame. If the elliptical exerciser rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL EXERCISER on page 12. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. First, see step 11 on page 10 and remove the link arms. Next, see step 4 on page 7 and remove the crank arms. Then, remove all of the screws from both side shields; there are three sizes of screws in the side shields-note which size of screw you remove from each hole. Then, gently pry the side shields away from the frame. Next, tighten the M8 x 35mm Screw (96) until the Belt 51 (51) is tight. Then, reattach the side shields, the crank arms, and the link arms. Note: If you have questions as 96 to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24. 19