Pyle PA305 Instruction Manual - Page 12
Using headphones, Connecting to standard AC power, Mounting the amplifier, Turning the amplifier
View all Pyle PA305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Using headphones To listen privately, or to monitor sound sources, connect a pair of low impedance stereo headphones (not supplied) with a 6.35 mm plug into the PHONES jack on the amplifier front panel. Please listen safely. Follow these recommendations: Do not listen at extremely high volume levels. Extended, high-volume listening can lead to permanent hearing loss. Always start with the volume control set to LOW level BEFORE you put the headphones on. Then gradually increase the volume as necessary. Once you set the volume, do not increase it. Over a period of time, your ears adapt to the volume level, so a volume level which does not cause immediate discomfort may still be actually damaging your hearing. Connecting to standard AC power After making all other connections, set the POWER switch to OFF position. Then connect the power cord to a standard AC outlet. Mounting the amplifier The PA 305 is designed to accept standard rack mounting installations. Two slots on each end of the front panel make it suitable for such an installation. Tightly secure four mounting screws (not supplied) through these four slots and into your standard electronics equipment rack. Turning the amplifier on 1.Turn on the audio input source equipment which is connected to the amplifier INPUT jacks. 2.Set all volume levels (Master, Mic 1-3, Mic 4/AUX and Line) to their minimum level settings. 3.Push in the power switch to turn the amplifier on. 4.Adjust the controls of MIC 1-3, Mic4/AUX and LINE to the desired volume and balance. 11