Pyle PA305 Instruction Manual - Page 15

PA 305 Specifications Output Power at THD 2%，8 Ohm Load 1 kHz 100W Total Harmonic Distortion (at 70 Watts, 8 Ohms 1 kHz, with Band Pass Filter) MIC (PHONE Jack) 0.25% MIC (XLR Jack) 0.35% AUX 0.20% PHONO 0.250% Input Sensitivity (at 2% THD 1 kHz) MIC (PHONE Jack) 1.35 mV MIC (XLR Jack) 1 mV AUX 150 mV PHONO 2.8 mV Signal to Noise Ratio (Input Shorted) with WTD MIC (PHONE Jack) 60dB MIC (XLR Jack) 54dB AUX 73dB PHONO 60dB Frequency Respones (atwatt,±3 dB) MIC (PHONE Jack) MIC (XLR Jack) AUX PHONO (RIAA 100 Hz/10 kHz) Notch filter Effect RANGE DEPTH Hum and Noise with 30 kHz Low Pass Filter at 8 Ohms 60 Hz-20KHz 75 Hz-20KHz 60 Hz-20KHz +12 dB/-12.5dB 300 Hz-3KHz -12dB MAS下ER VOLUME MIN 0.75mV MASTER VOLUME MAX. Other MIN 6mV Power Requirements AC 115V/230V Switchable Dimensions 4 3 16 ×1815 16×1115 16 I nches(HWD) (10.0×48.0×27.3 CM) Cautions: Before you connect the speakers, be sure the total wattage of the primary tap you intend to use does not exceed the amplifier's maximum 100-watt output power rating. Avoid multiple connections to the amplifier's 70v and COM terminals. 14