Pyle PLD43MU PLD43MU Manual 1 - Page 19

Basic Operation Balance: R10 to L10 Adjust sound balance between left and right speakers by using VOL + / - . Fader: F10 to R10 Adjust sound balance between front and rear speakers by using VOL + / VOL - . Setting Audio Modes front panel to ahead/back (proceed/ cancel) , and then press the SETUP button briefly to confirm . (Press it button longer again to renew . ) FM1 106.30 MHz ST DX LUD SWF POP DISC 11:08 AM DSP Touch the screen the DSP range (or press the EQ button on the front panel ) to select one of the preset sound modes (Rock/Pop/Jazz/Classic/Flat) . The information will display in the monitor as follow : POP ROCK JAZZ FLAT CLASSIC ROCK SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ Alternate Audio/video Source Following the diagram below, to connect analogue replay devices. Use this jack to replay sound of other replay equipment such as DVD players, computers, etc. Via the loudspeakers. 1).Please connect the external device with stereo jack(black end) plug the Aux in socket of the unit . 2).Press the MOD button to select the AUX IN connection. 3).With the buttons on the external device to operate the item of the playing. Headphones port MENU touch to select It`s depend on your habit to select the Audio mode . Scroll Caption Adjustment In Radio mode: You can adjust your desired scroll caption , the method of the operation as follow: a). Press and hold the SETUP button (for about 2 seconds) on the remote control, the adjustment scroll bar will display on the screen . b). Use the VOL+/- to select among of the "A, B, C ....X, Y, Z, and blank ", and use the / button on the 18 Black White ( connect cable) AUX IN SWF POP DISC 11:08 AM SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ touch to select