Pyle PLDVRCAMAND75 Instruction Manual - Page 18
Installation Instructions, B+ Yellow line, ACC+ Red line, GND Black line, Reverse Control Line Red
View all Pyle PLDVRCAMAND75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Instructions 1. Ensure that the vehicle is in a power off state 2. Remove the original car host and host support and then the navigation recorder host and host frame fixed in the original car windshield. 3. BMW will be transferred to the line and the external transfers line to the good and then extend the line along the car windshield edge into the car to the car. 4. The host side of the original car line is divided into 4 B+ (Yellow line) Open the box when the car is not turned on, using a DC block test with a million 12V voltage that is connected to the (B+) ACC+ (Red line) Open the box, in the start of the state of the car (do not start when the voltage is 0V) with a DC block test with a 12V voltage at the (ACC+). GND (Black line) Open the safe box around the iron to find a reliable ground source to connect (GND) Reverse Control Line (Red line) Open rear end case, find the position of the back lamp joint. Start the car, hang reverse gear (R) gear, 12V voltage; neutral (N) to the end of the 0V line connected (reverse control line) www.PyleUSA.com 17