Ridgid WD1851 Owners Manual - Page 13

SP6733-2 Ridgid WD1851 ES 2/3/12 2:04 PM Page 13 Accessory and Hose Storage Your accessories may be stored in the removable tote, or in the two locations on the caddy right/left. Either the hose or the wands may be stored in the two areas marked Hose Storage. The hose may be stored by wrapping it around the unit and plugging the open end into one of the storage locations on the caddy assembly. Alternatively, the wands may also be stored in this location by plugging either of the ends of the wands onto the storage receivers located on the caddy. Accessory Storage Compartment Cord Wrap When vacuuming is complete, unplug the cord and wrap it around the power assembly as shown. The cord should wrap under the pull handle (above the inlet) and around and under the cord wrap of the motor cover. Push/Pull Handle Cord Wrap STHOORSAEGE STHOORSAEGE Hose Storage Area Power Cord Maintenance Filter ! WARNING: To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter. ! WARNING: Do not operate without filter cage and float, as they prevent liquid from entering the impeller and damaging the motor. WD1851 Professional Wet/Dry Vac is supplied with RIDGID's best Qwik Lock™ Fine Dust Filter. Replacement Qwik Lock™ Fine Dust Filters are available where you purchased your Vac. Ask for the RIDGID Qwik Lock™ Fine Dust Filter VF5000. Filter Removal Refer to page 6 "Filter Removal and Installation" Section of this manual. IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the filter before using the Vac for dry material pick-up. NOTE: The filter is made of high quality paper designed to stop very small particles of dust. The filter can be used for wet or dry pick up. Handle the filter carefully when removing to clean or installing it. Creases in the filter pleats may occur from installation but not affect the performance of the filter. 13