Ryobi P125 Operation Manual - Page 6
Operation - problem
View all Ryobi P125 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
OPERATION NOTE: The LED charge indicator light will not work if the battery protection feature has caused the battery pack to stop powering the tool. When the battery pack resets itself, the LED will again function. LED FUNCTIONS OF CHARGER See Figures 4 - 5, pages 9 - 10. Blue led status button Charger has blue LED status button to indicate power on . Refer to chart on page 9. When batteries are charging , the blue LED status button will maintain a full and constant brightness. While batteries are in maintenance mode, the blue LED status button will slowly pulse. When maintenance mode is complete, charger goes into energy save mode. Blue status button will maintain a fluctuating pulse while in energy save mode. When batteries are not being charged, maintained or when the charger does not hold any batteries. NOTE: Battery port LEDs will turn off during maintenance mode and energy save mode. Charger awakens from energy save mode when status button is pressed or automatically after 5 days in energy save mode. Battery port leds Red LED on, Green LED off = Battery installed. Red LED flashing, Green LED off = Battery is being tested. Red LED on, Green LED flashing = Battery is charging. Red LED off, Green LED on = Battery is fully charged. Red LED flashing, Green LED flashing, simultaneously = Battery is defective. Red LED flashing, Green LED flashing, alternating = Battery port is defective. CHARGING THE BATTERY PACK This charger will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. Use only Ryobi One+ 18 V battery packs with this charger: BATTERY PACK (P104 Li-ion) 130429001, 130429002,130155001 (P103 Li-ion) 130429004 (P100 Ni-Cd) 130255004, 130224028 CHARGER (P125) 140108001 CHARGING A BATTERY PACK If the charger does not charge the battery pack under normal circumstances, take both the battery pack and charger to your nearest Authorized Service Center for electrical check. Use battery pack only with the recommended charger. Connect the charger to the power supply. Make sure the power supply is normal household voltage, 120 volts, AC only, 60 Hz. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured in the charger before beginning operation. Place the battery pack in the charger aligning raised rib on the battery pack with the groove in the c harger. Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger. Do not place the charger and battery pack(s) in an area of extreme heat or cold. They will work best at normal room temperature. Note: The charger and battery pack(s) should be placed in a location where the temperature is more than 50°F but less than 100°F. The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem. After charging is complete, the green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply or until charger enters maintenance mode/energy save mode. To remove the battery pack(s) from the charger, depress the latches on each side of the battery pack. CHARGING A HOT BATTERY PACK If the battery pack is above normal temperature range, the red LED will begin flashing and the green LED will be off. When the battery pack cools down to approximately 122°F, the charger will automatically begin fast charge mode. CHARGING A COOL BATTERY PACK If the battery pack is below normal temperature range, the red LED will begin flashing and the green LED will be off. When the battery warms to a temperature of more than 32°F, the charger will automatically begin charge mode. COLD WEATHER OPERATION The lithium-ion battery pack can be used in temperatures down to -4°F. Put the battery pack on a tool and use the tool in a light duty application. After about a minute, the pack will have warmed up and begin operating normally. 6 - English