Ryobi TS1346 Operation Manual - Page 16
View Of Blade Not Square
View all Ryobi TS1346 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ADJUSTMENTS I The edge of the square and the saw blade should be parallel as shown in figure 17. I If the front or back edge of the saw blade angles away from the square as shown in figures 18 and 19, adjustments are needed. I Loosen the socket head screws that secure the miter fence to the miter table. See Figure 16. I Rotate the miter fence left or right until the saw blade is parallel with the square. I Retighten the screws securely and recheck the bladeto-fence alignment. Your saw has two scale indicators, one on the bevel scale and one on the miter scale. After squaring adjustments have been made, it may be necessary to loosen the indicators screws and reset them to zero. See Figure 20. MITER FENCE MITER FENCE BLADE MITER FRAMING TABLE SQUARE VIEW OF BLADE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 18 MITER FENCE BLADE MITER LOCK PLATE FRAMING SQUARE MITER TABLE MITER LOCK HANDLE VIEW OF BLADE SQUARE WITH FENCE Fig. 17 BLADE MITER TABLE FRAMING SQUARE VIEW OF BLADE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 19 33.6 30 22.5 15 33.6 30 22.5 0 15 45 INDICATOR SCREW INDICATOR POINT BEVEL SCALE 45 INDICATOR SCREW MITER SCALE SCALE INDICATOR Page 16 SCALE INDICATOR Fig. 20