Ryobi TS1346 Operation Manual - Page 25
Clamping Wide Workpieces, Cutting Warped Material
View all Ryobi TS1346 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
45 45 45 45 OPERATION Bevel Angle Setting 33.85° 33.85° 33.85° 33.85° Type of Cut Left side, inside corner 1. Top edge of molding against fence 2. Miter table set right 31.62° 3. Save left end of cut Right side, inside corner 1. Bottom edge of molding against fence 2. Miter table set left 31.62° 3. Save left end of cut Left side, outside corner 1. Bottom edge of molding against fence 2. Miter table set left 31.62° 3. Save right end of cut Right side, outside corner 1. Top edge of molding against fence 2. Miter table set right 31.62° 3. Save right end of cut CUTTING WARPED MATERIAL See Figures 32 and 33. When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 32. If the warped material is positioned the wrong way as shown in figure 33, it will pinch the blade near the completion of the cut. 33.6 30 22.5 15 33.6 30 22.5 0 15 WRONG Fig. 33 WARNING: To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence. CLAMPING WIDE WORKPIECES See Figure 34. When cutting wide workpieces, such as 51 mm x 152 mm (52 in. x 6 in.), boards should be clamped with a C-clamp as shown in figure 34. 33.6 30 22.5 15 33.6 30 22.5 0 15 RIGHT Fig. 32 Page 25 0 WIDE BOARD Fig. 34