Ryobi TSS101L English Manual - Page 15

ASSEMBLY NOTE: Many of the illustrations in this manual show only portions of the compound miter saw. This is intentional so that we can clearly show points being made in the illustrations. Never operate the saw without all guards securely in place and in good operating condition. locking / unlocking the saw arm See Figure 9. To unlock and raise the saw arm:  Firmly grasp the "D" handle and apply downward pressure while at the same time pulling the lock pin out and away from the saw housing. Rotate lock pin 90º to lock (or unlock) the saw arm.  Release the lock pin and slowly raise the saw arm. To lock the saw arm:  Firmly grasp the "D" handle and apply downward pressure while at the same time pulling the lock pin out and away from the saw housing.  Release the lock pin allowing it to lock the saw into place. DUST BAG See Figure 10. A dust bag is provided for use on this miter saw. It fits over the exhaust port on the upper blade guard. NOTE: the exhaust port also accepts 1-1/4 in. vacuum hose. To install:  Squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port.  Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port. To remove the dust bag for emptying:  Reverse the above procedure. "D" Handle dust bag Exhaust Port Lock Pin Fig. 9 Fig. 10 15