Ryobi TSS101L English Manual - Page 31

Warning, Clamping Wide Workpieces, Cutting Warped Material

Get Ryobi TSS101L PDF manuals and user guides View all Ryobi TSS101L manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

OPERATION cutting warped material 8 See Figures 37 - 38. When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 37. If the warped material is positioned the wrong way as shown in figure 38, it will pinch the blade near the completion of the cut. Right WRONG Fig. 38 Fig. 37 WARNING: To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence. clamping wide workpieces See Figure 39. When cutting wide workpieces, such as 2 in. x 6 in., boards should be clamped with a work clamp as shown in figure 39. WIDE BOARD Fig. 39 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
31
OPERATION
WRONG
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 39.
When cutting wide workpieces, such as 2 in. x 6 in., boards
should be clamped with a work clamp as shown in figure 39.
Fig. 39
WIDE
BOARD
Fig. 38
8
CUTTING WARPED MATERIAL
See Figures 37 - 38.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 37.
If the warped material is positioned the wrong way as shown
in figure 38, it will pinch the blade near the completion of
the cut.
Fig. 37
RIGHT