Ryobi TSS101L English Manual - Page 24
To Bevel Cut
View all Ryobi TSS101L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
OPERATION TO Bevel Cut See Figures 28 - 29. A bevel cut is made by cutting across the grain of the workpiece with the blade angled to the workpiece. A straight bevel cut is made with the miter table set at the zero degree position and the blade set at an angle between 0° and 45°. Pull out the lock pin and lift saw arm to its full height. Loosen the miter lock handle. Rotate the miter lock handle approximately one-half turn to the left to loosen. Rotate the control arm until the pointer aligns with zero on the miter scale. Tighten the miter lock handle securely. Loosen the bevel lock lever and move the saw arm to the left to the desired bevel angle. Bevel angles can be set from 0° to 45°. Align the indicator point for the desired angle. Once the saw arm has been set at the desired angle, securely tighten the bevel lock lever. Place the workpiece flat on the miter table with one edge securely against the fence. If the board is warped, place the convex side against the fence. If the concave edge of a board is placed against the fence, the board could collapse on the blade at the end of the cut, jamming the blade. See Figures 38 - 39. When cutting long pieces of lumber or molding, support the opposite end of the stock with a roller stand or with a work surface level with the saw table. See Figure 32. Align the cutting line on the workpiece with the edge of saw blade. Grasp the stock firmly with one hand and secure it against the fence. Use the optional work clamp or a C-clamp to secure the workpiece when possible. Before turning on the saw, perform a dry run of the cutting operation just to make sure that no problems will occur when the cut is made. Grasp the saw handle firmly then squeeze the switch trigger. Allow several seconds for the blade to reach maximum speed. Slowly lower the blade into and through the workpiece. Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of workpiece. Wait until the electric brake stops blade from turning before removing the workpiece from miter table. INDICATOR POINT BEVEL SCALE WORK CLAMP Bevel Cut INDICATOR SCREW scale indicator Fig. 28 Fig. 29 24