Samsung HPN4239 User Manual (user Manual) (ver.1.0) (English) - Page 9

4 Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on the PDP (Œ) to secure it to the wall mount bracket. (´) Tighten the screws as shown (ˇ) so that the PDP cannot be separated from wall mount bracket. PDP panel Wall Wall attachment panel bracket 16 How to Adjust Mounting Angle Notice : Please secure the mounting bracket on the wall surface after setting its angle at 0° Factory default The wall mount bracket is delivered separately.Please tighten the captive screw in the direction of the arrow after assembling the bracket. Changing the angle 1 Secure the PDP to the wall mount bracket.(Please refer to the following instructions.) 2 Set the angle by pulling the upper end of the PDP attached to bracket in the direction of the arrow. 3 The angle can be adjusted from 0° to 20° by ±2°. 1. Contact an authorized technician when installing the wall attachment panel. 2. After hanging the PDP panel on the wall attachment panel, make sure that the Insulation holders are completely hung. 3. Be careful not to get your fingers caught during installation. 4. Make sure the wall attachment panel brackets are tightened. Otherwise, the PDP panel may fall down. 17