Samsung NV51M9770DS Installation Guide - Page 12

Electrical connection

Get Samsung NV51M9770DS PDF manuals and user guides View all Samsung NV51M9770DS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Installation instructions Installation instructions 4. Lower the oven door to the fully open position. If the oven door does not open to a full 90°, repeat steps 1 through 3. 5. Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position. See Step 1 (illustration A) in the "Remove Oven Door(s)" section for proper locked position. 6. Close the oven door. 7. When the hinges are properly installed and the door closed, there should be an even gap between the door and the control panel. If one side of the oven door is hanging lower than the other, the hinge on that side is not properly installed. 8. Connect Wire Harness. Electrical connection For Double Ovens WARNING Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge solid copper wire. Make sure to ground the oven. Failure to follow these instructions can result in death, fire, or electrical shock. This oven is manufactured with a neutral (white) power supply wire and a cabinet- connected ground (green or bare) wire twisted together. 1. Disconnect power. 2. Feed the flexible conduit from the oven A through the opening in the cabinet. 3. Remove junction box cover if it is present. 4. Install a UL listed or CSA approved A. UL listed or CSA approved conduit connector conduit connector to the junction box. 5. Route the flexible conduit from the oven to the junction box through a UL listed or CSA approved conduit connector. 6. Tighten screws on conduit connector. 7. See "Electrical Connection Options Chart" to complete installation for your type of electrical connection. 12 English Install_NW9000K_CHEF_WALL-DG68-01005A-00_EN+MES+CFR.indb 12 7/31/2017 4:43:20 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
12 English
Installation instructions
Installation instructions
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 1 (illustration A) in the
“Remove Oven Door(s)” section for
proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8.
Connect Wire Harness.
Electrical connection
For Double Ovens
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Make sure to ground the oven.
Failure to follow these instructions can result in death, fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply wire and a cabinet-
connected ground (green or bare) wire twisted together.
A
A.
UL listed or CSA approved
conduit connector
1.
Disconnect power.
2.
Feed the flexible conduit from the oven
through the opening in the cabinet.
3.
Remove junction box cover if it is
present.
4.
Install a UL listed or CSA approved
conduit connector to the junction box.
5.
Route the flexible conduit from the
oven to the junction box through a
UL listed or CSA approved conduit
connector.
6.
Tighten screws on conduit connector.
7.
See “Electrical Connection Options
Chart” to complete installation for your
type of electrical connection.
Install_NW9000K_CHEF_WALL-DG68-01005A-00_EN+MES+CFR.indb
12
7/31/2017
4:43:20 PM