Samsung NV51M9770DS Installation Guide - Page 14
Install oven
View all Samsung NV51M9770DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installation instructions Installation instructions 3-Wire Cable from Home Power Supply - U.S. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. A 1. Connect the 2 black wires (C) together B using a UL listed wire connector. 2. Connect the 2 white wires (D) and C G the green (or bare) ground wire (of H the oven cable) using a UL listed wire D connector. 3. Connect the 2 red wires (G) together using a UL listed wire connector. E I 4. Install junction box cover. F A. Cable from home power supply B. Junction box C. Black wires (normally L1) D. White wires (normally N-neutral) E. green wires (normally G-ground) F. 4-wire flexible conduit from oven G. Red wires (normally L2) H. UL listed wire connectors I. UL listed or CSA approved conduit connector Install oven 1. Using 2 or more people, lift the oven partially into the cabinet cutout. Hang the install handle onto the side hook of the oven as shown below. NOTE Carefully push against front oven frame. Install Handle 2. Push against the seal area of the front frame to push the oven into the cabinet until the back surface of the front frame touches the front wall of the cabinet. 3. Push oven completely into the cabinet and center the oven into the cabinet cutout. 4. Remove the tape from front trims. • Securely fasten the oven to the cabinet using the screws provided. • Insert the screws through hole in trim aligning with hole in oven frame. Do not overtighten screws. 14 English Install_NW9000K_CHEF_WALL-DG68-01005A-00_EN+MES+CFR.indb 14 7/31/2017 4:43:21 PM