Samsung NX58K3310SS/AA Installation Guide - Page 24

Installation instructions Step 6. Level the range Leveling leg 1. Make sure the range is positioned where you want it. 2. Using a wrench, level the range by turning the front leveling legs in or out as necessary. Counterclockwise shortens the leg and lowers the range. Clockwise lengthens the leg and raises the range. NOTE Adjusting the two front legs is usually sufficient, but all four legs adjust if necessary. NOTE Adjust the leveling legs only as far as necessary to level the range. Extending the leveling legs more than necessary or removing legs can cause the range to be unstable. 3. If range is next to or between cabinets, make sure the cooktop (without the surface burner grates) is level with the countertops. 4. Position an oven rack in the center rack position. 5. Check the level of the range with a carpenter level using the two positions shown at right. 6. After the range becomes level, slide the range away from the wall so that the anti-tip bracket can be installed. Step 7. Assemble the surface burners CAUTION Do not operate the surface burners without all burner parts in place. 1. Position surface burner heads on top of the surface burner manifolds as shown at right. The electrodes will fit into the slot in the bottom of the heads. Make sure the surface burner heads are flat and parallel with the cooktop. 2. Place the matching size caps on top of each surface burner head. Precise Simmer Burner (RR) Flat surface Concave line NOTE The caps on Precise simmer burner (RR) and inside Dual Burner (RF) can be interchangeably used. 3. Place the left, center, and right surface burner grates on the cooktop. The edges of the grates should match up with the edges of the cooktop. Installation instructions 24 English