Samsung NX58R9311SS/AA Installation Guide - Page 24
Step 8. Check the ignition of surface burners, English, To turn on a surface burner
View all Samsung NX58R9311SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Installation instructions Step 8. Check the ignition of surface burners Check the operation of all cooktop and oven burners after the range has been installed and assembled, gas supply lines have been carefully checked for leaks, and electrical power cord has been plugged in. All surface and oven burners have electronic ignition. To turn on a surface burner: 1. Push in and turn the control knob for that 2 surface burner to the Lite position. The "clicking" sound indicates the electronic ignition system is operating properly. The 1 burner will light in about 4 seconds, after the air has been purged from the supply line. 2. After the burner lights, turn the control knob to the desired setting. The "clicking" sound will stop and the flame height will change from Max. to Min. during turning the control knob. 3. Repeat steps 1 and 2 to check the operation of each surface burner in succession. NOTE Place food in the oven after preheating if the recipe calls for it. Preheating is important for good baking results. After the oven has reached the desired cooking temperature, it will beep 6 times. To start the bake burners 1 3 2 4 1. Press the Bake pad. 2. If necessary, use the number pad to change the default temperature (350 °F). You can set the oven to any temperature from 175 °F to 550 °F. 3. Press the START/SET pad. • The gas oven preheats until it reaches the temperature you set. • When preheating is complete, place the food in the gas oven, and then close the door. 4. When cooking is complete, press the OVEN OFF pad, and then take out the food. To start the broil burners 2 3 7 1. Put food on a broiling grid in a broiling pan, and then place the pan on the desired rack. 2. Press the Broil pad once for high temperature broiling or twice for low. 3. Press the START/SET pad to start cooking. 4. Let the oven pre-heat for 5 minutes. 5. Place the pan on the desired rack, and then close the oven door. 24 English Installation instructions Install_NX58R9311SS_AA_DG68-00906B-00_EN+MES+CFR.indb 24 2019-06-03 2:18:20