Samsung RF220NCTASP/AA User Manual Ver.0.1 (English, French, Spanish) - Page 11

01 SETTING UP FLOORING For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 286.6 lbs (130 kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side. ACCESSORIES AND REQUIRED TOOLS The following accessories are included with your refrigerator: REMOVING THE REFRIGERATOR DOORS Before removing the door/drawer, make sure you read the following items: Disconnect power to the refrigerator before WARNINGremoving the door or drawer. • Be careful not to drop, damage or scratch the door/drawer while removing them. • Be careful not to get injured while removing the door/drawer. • Reattach the door/drawer properly to avoid: - Moisture from air leakage. - Uneven door alignment. - Wasting energy due to improper door seal. Disassembling the fridge door Be careful not to drop and scratch the WARNING doors while removing the doors. 1. Remove the 3 screws holding down the top table and remove it. Hex wrench Required Tools (Not provided) You need the following tools to complete the installation of your refrigerator: Top Table 2. Disconnect electric wire on the top of the refrigerator. Philips Flat-blade screw Socket wrench screwdriver(+) driver(-) (10 mm) Pliers Allen wrench (3/16") (5 mm) setting up _11 %""JOEC