Samsung RF220NCTASP/AA User Manual Ver.0.1 (English, French, Spanish) - Page 16
Installation Of The Water
View all Samsung RF220NCTASP/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
INSTALLATION OF THE WATER LINE Before You Install the water line • The water line installation is not warranted by the refrigerator manufacturer. So before you install the water line, read the whole steps for installing and follow these instructions carefully to minimize the risk of expensive water damage. • Banging pipes (water banging in the pipes) in house plumbing can cause damage to fridge parts and lead to water leakage or flooding. Call a qualified plumber to correct the problem before installing the water supply line to the fridge. • To prevent burns and product damage, do not hook up the water line to the hot water line. • Do not install the water line in areas where temperatures fall below freezing. • When using any electrical device (such as a power drill) during installation, be sure the device is insulated or wired in a manner to prevent electric shock. • All installations must be in a accordance with local plumbing code requirements. • Water line Kit and water filter are not covered by Samsung's Warranty. The manufacturer (or dealer, installer) of them is responsible for any defects and all the loss caused by water filter & water line kit. • The filter should be replaced according to manufacturer (or dealer)'s instruction. • To order additional water filters, please contact the manufacturer (or dealer) of the filter. Using the water filter (not provided) Connecting to water supply line • Shut off the main water supply line and turn the Ice maker to the off position. • Locate the nearest cold drinking water line. • Follow the instructions in the water filter installation kit. • After connecting the water supply line to the Cartridge Holder inlet and installing the Filter Cartridge (insert plastic line in fully). • Turn on water supply and Flush 3 gallons through filter before use (flush approximately 6 minutes) 1. Cold Water line 2. Pipe Clamp. 3. Plastic line 4. Compression Nut 5. Compression Sleeve 6. Packing Nut 7. Shut Off Valve 8. Filter Cartridge 9. Cartridge Holder 90 degree • The water filter must be installed outside the refrigerator. It is not provided with your new refrigerator. The filter cartridge (8) and holder (9) kit can be purchased from the retailer where you purchased this refrigerator. • Do not use copper line. • Cut the tubing, making sure the ends are square and clean. Incorrect Correct There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. Use Copper Tubing • ¼" copper tubing • ¼" compression nut (1pc) • Ferrule (2pc) Use Plastic Tubing • ¼" plastic tubing → Molded end(Bulb) • ¼" compression nut (1pc) Connect the water line to the fridge • Connect the plastic line on the back of your fridge to the cartridge holder outlet (fully insert the plastic line to the cartridge holder outlet). • Insert plastic clip to the cartridge holder inlet and outlet. • Turn water on and check for any leakage. 16_ setting up %""JOEC