Samsung RF4287HARS User Manual - Page 6

• Do not install the refrigerator where the temperature will go below 50ºF (10ºC). • Do not locate the refrigerator where it may become wet. When moving your refrigerator To prevent floor damage, be sure the front adjusting legs are in the up position (above CAUTION the floor). Refer to 'Adjusting the doors' in the manual (on page 9). Hex wrench Fastener Required Tools (Not provided) You need the following tools to complete the installation of your refirgerator: Philips screwdriver Flat-blade (+) screwdriver (-) Socket wrench (10mm) Flat-blade Control Lever screw driver(-) FLOORING For proper installation, this refrigerator must be placed on a leveled surface of hard material that is the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 359lbs (165kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving a refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side. Pliers Allen wrench (3/16") (5mm) REMOVING THE REFRIGERATOR DOORS Some installations require door removal to transport the refrigerator to its final location. Do not remove the door/drawer if you don't need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 8. If you need to remove the doors. continue below. Before removing the door/drawer, make sure you read the following items: ACCESSORIES AND REQUIRED TOOLS The following accessories are included with your refigerator: Disconnect power to the refrigerator before removing the door or drawer. WARNING • Be careful not to drop, damage or scratch the door/drawer while removing them. • Be careful not to get injured while removing the door/drawer. • Reattach the door/drawer properly to avoid: - Moisture from air leakage. - Uneven door alignment. - Wasting energy due to improper door seal. 06_ setting up %""JOEC


 1.