Samsung SCD-3080 User Manual - Page 7

Installation Installation Notes • The installation should be done by qualified service personnel or sytem installers. • If the ceiling material is not strong enough to hold the installation screws, the camera may fall off. Reinforce the ceiling as needed. 1) Separate the dome cover by rotating anti-clockwise. 2) Separate the shield case by pulling from the camera body. * To install the dome cover on the camera body, turn the latches in locking direction as Latch shown in the Figure-1. Locking direction [Figure-1] Unlocking direction (Anti-clockwise) Main Body (Camera) Shield Case Locking direction (Clockwise) Dome cover COLOR DOME CAMERA 12 SUD-3080 When installing on a adapter plate An arrow for installing directions Adapter plate M4 tapping screw (provided) CAMERA 1) Place the bracket provided on the installation surface and fix it with the M4 tapping screws (provided). 2) When placing the camera body on the plate, insert the plate pin into the mounting hole on the body as shown in Figure-2 and fix it by turning clockwise. 3) When placing the camera body on the plate, make sure the camera cables pass through their respective designated holes.(When placing the cable through its side, thread it through the hole at the bottom.) 4) After installation and adjustment of the camera are complete, secure the dome cover by turning it clockwise. Locking direction Plate pin Unlocking direction Dome cover Unlocking direction Locking direction Notes [Figure-2] • Please locate an arrow on bracket for installing direction that you wish to observe Area and then fix it with the M4 tapping screws. COLOR DOME CAMERA 13 SUD-3080