Samsung SSC-1000 User Guide - Page 9

SSC-1000 (gb) 2009.1.8 1:38 PM Page 14 User's Guide $-1 PASSWORD SETUP - For password input, move CURSOR(→) to PASSWORD SET, press ENTER, and put in the 4-digit number. - For the selection regarding whether to use a password or not, move CURSOR(→) to disable (or enable), and press ENTER. Each time you press a button, enable and disable change. When you come out of the set-up mode press the MENU button. → PASSWORD SET ENABLE $-2 BAUD RATE SETUP Move CURSOR(→) to the Baud rate you want, and press the ENTER button. ∗ 38400, 19200, 9600, 4800, 2400, 1200 → 38400 19200 9600 4800 $-3 PROTOCOL SETUP Place the CURSOR (→) over a desired protocol and press the ENTER button. ∗ SAMSUNG, PELCO-D, PELCO-P, VICON PANASONIC, KALATEL, DIAMOND, AD, PHILIPS, ERNA, VCL TP, TECHWIN, HONEYWELL → SAMSUNG PELCO-D PELCO-P VICON $-4 When you set up the controller address, move CURSOR(→) to ADDRESS NO., press and ENTER button, put in the number, and press the ENTER button. ∗ If only one unit is used, set to "0". ∗ You can not control the currently operating device in other place, and a message of "BUSY" appears if you try to do so. 14 % CAMERA SET If you want to make a set-up related to the Samsung Dome Camera, move CURSOR(→) to CAMERA SET in the main menu, and press the ENTER button. After this, you can set up while watching the OSD menu screen in a monitor in which camera visuals can be displayed. M ON = [ 0 0 ] CAM=[ 0 0 0 ] →CAMERA MENU PRESET S ET DATA BACK UP MON = [00] CAM = [000] ∗ CAMERA SETUP ∗ ^ MATRIX SET If you want to make a set-up related to the matrix switcher, move CURSOR(→) to MATRIX SET in the main menu, and press the ENTER button. After this, you can set up while watching the OSD menu screen in a monitor in which camera visuals can be displayed. ∗ MATRIX SET ∗ MENU KEY: < EXIT > & PRESET SET In order to set up the preset of the receiver unit (or Samsung Dome Camera), move CURSOR(→) to PRESET SET in the CAMERA SET MENU, and press the ENTER button. First, move CURSOR(→) to preset no., press the ENTER button, put in the number, and press the ENTER button. Next, move CURSOR(→) to position set, control pan/tilt and the lens, and press the ENTER button. If you want to cancel the concerned preset no., move CURSOR(→) to delete, and press the ENTER button. If you want to go back to the main menu, press the MENU button. M ON = [ 0 0 ] CAM=[ 0 0 0 ] →PRESET NO [ 000 ] POS I T I ON SET DE L E TE 15