Sanyo PDG-DWL2500 Owners Manual - Page 56
Image, Normal, Enhanced, Sound, Computer, Monitor out, Video, Network, Standby mode, Terminal
UPC - 086483079061
View all Sanyo PDG-DWL2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Setting HDMI setup This function is only used for HDMI input source. Image Select Normal or Enhanced to match the video range setting of your HDMI Digital RGB equipment. Sound HDMI When using the HDMI cable, select HDMI. Both video and audio* are transferred and you need not to connect any additional cables for audio. * This HDMI terminal supports Linear PCM (32kHz/44.1kHz/48kHz). Computer... When using the DVI-HDMI cable, select Computer and connect the audio cable to COMPUTER/COMPONENT AUDIO IN terminal. The names for the output setting of Digital RGB vary from equipment to equipment. For details, refer to the owner's manual of your Digital RGB equipment. When the black parts of the image are destroyed or stand out, please switch to Normal or Enhanced, and then switch the output type of the HDMI Digital RGB output equipment. HDMI setup Terminal The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or monitor output (p.11). Computer 2......Computer input Monitor out......Monitor output Terminal function is not available when Computer 2 to the input source is selected. Change the input source to the others (Computer 1, Video, S-video or HDMI) so that the Terminal function is available (pp.30-31, 41-42). Standby mode This function is available when operating the projector via network. Network..... Supply the power to the network function even after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off. Eco Select Eco when you do not use the projector via network. The projector's network function will stop when turning off the projector. Refer to the owner's manual of "Network Set-up and Operation". 56 4Note: • Factory default is Network. • W hen Eco is selected and the projector is in Stand-by, the communication of RS232C serial port is not available.