Sanyo PLC-XU355 Instruction Manual, PLC-XU355 - Page 9
Rear Terminal, USB Connector Series - video
UPC - 086483073847
View all Sanyo PLC-XU355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Rear Terminal ① ② ③ Part Names and Functions ④ ⑤ ⑫⑪ ⑩⑨ ⑧⑦ ⑥ ① CONTROL PORT When the projector is controlled by a computer, connect to this jack with serial control cable. ② COMPUTER IN 1 / COMPONENT IN Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.16,18). ③ MONITOR OUT This terminal can be used to output the incoming analog RGB signal from COMPUTER IN 2 / DVI-I terminal or COMPUTER IN 1/COMPONENT IN terminal to the other monitor (p.16). ④ COMPUTER IN 2 / DVI-I Connect computer output (Digital/Analog DVI-I type) to this terminal (p.16). ⑤ LAN Connection Terminal Connect the LAN cable (refer to the owner's manual "Network Set-up and Operation"). ⑥ USB Connector (Series A) Connect the USB cable (refer to the owner's manual "Network Set-up and Operation"). ⑦ S-VIDEO IN Connect the S-VIDEO output signal from video equipment to this jack (p.17). ⑧ AUDIO OUT (VARIABLE) Connect an external audio amplifier to this jack (pp.16-18). This terminal outputs sound from AUDIO IN terminal (⑨ or ⑩). ⑨ COMPUTER 1 / COMPUTER 2 AUDIO IN Connect the audio output (stereo) from a computer or video equipment connected to ② or ④ to this jack. (pp16, 18) ⑩ AUDIO IN Connect the audio output signal from video equipment connected to ⑦ or ⑪ to this jack. For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.17). ⑪ VIDEO IN Connect the composite video output signal to this jack (p.17). ⑫ USB Connector (Series B) In order to operate the computer with the remote control and use the PAGE ▲▼buttons on the remote control during a presentation, connect the USB port of the computer to the USB terminal with a USB cable (not supplied) (p.16).