Sanyo PLC-XU47 Owners Manual - Page 24

Computer Input Input Source Selection Direct Operation Choose either Computer 1 or Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control. Before using these buttons, correct input source should be selected through menu operation as described below. INPUT button Computer 1 Computer 2 ✳ Video COMPUTER button Computer 1 Computer 2 ✳ ✳ See Note on the bottom of this page. Menu Operation 1 Press the MENU button and the On-Screen Menu will appear. Press the Point 7 8 button to move the red frame pointer to the Input Menu icon. 2 Press the Point d button to move the red arrow pointer to either Computer 1 or Computer 2, and then press the SELECT button. 3 After the Source Select Menu appears for Computer 1, move the pointer to RGB and then press the SELECT button. RGB When the input source is analog coming from a computer through the COMPUTER IN 1/ COMPONENT IN terminal, select RGB. Component See "Selecting Input Source (Component / RGBScart 21-pin )" on p33. RGB (Scart) See "Selecting Input Source (Component / RGBScart 21-pin )" on p33. Input Menu Computer 1 Input Menu Input Menu icon Move the pointer (red arrow) to Computer 1 and press the SELECT button. Source Select Menu Move the pointer to RGB and press the SELECT button. Move the pointer (red arrow) to Computer 2 and press the SELECT button. ✔Note: Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is used as Monitor out. (p41) 24