Sanyo PLV-60HT Owners Manual - Page 41

Problem, Try these Solution - model

Get Sanyo PLV-60HT - WXGA LCD Projector PDF manuals and user guides View all Sanyo PLV-60HT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

APPENDIX Problem: Remote Control Unit does not work. Try these Solution q Check the batteries. q Make sure nothing is between the Remote Receiver and the Remote Control Unit. q Make sure you are not too far from projector when using the Remote Control Unit. Maximum operating range is 16.4' (5m). q Make sure the code of the Remote Control is set to conform to projector. (See "SETTING" section on page 36, 37.) WARNING : High voltages are used to operate this projector. Do not attempt to open the cabinet. If the problem still persists after following all operating instructions, contact the sales dealer where you purchased projector or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service. This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards. 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
41
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc.
It is designed and manufactured to meet rigid U.L. safety standards
against risk of fire, casualty and electrical hazards.
APPENDIX
WARNING :
High voltages are used to operate this projector.
Do not attempt to open the cabinet.
If the problem still persists after following all operating instructions, contact the sales dealer where you
purchased projector or the service center.
Give the model number and explain the difficulty.
We will advise you
how to obtain service.
Remote Control Unit
does not work.
●
Check the batteries.
●
Make sure nothing is between the Remote Receiver and the Remote Control Unit.
●
Make sure you are not too far from projector when using the Remote Control Unit.
Maximum operating range is 16.4’ (5m).
●
Make sure the code of the Remote Control is set to conform to projector.
(See “SETTING” section on page 36, 37.)
Problem:
Try these Solution