Sanyo PLV Z1 Owners Manual - Page 14
Remote Control Batteries Installation, Operating Range
UPC - 086483045776
View all Sanyo PLV Z1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Part Names and Functions Remote Control Batteries Installation 1 Remove the battery compartment lid. Pull up the lid and remove it. 2 Slide the batteries into compartment. Two AA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. 3 Replace the compartment lid. * When the batteries of the remote control are replaced, the remote control code automatically returns to the initial code (Code 2)(p43). To insure safe operation, please observe the following precautions: G Use (2) AA, UM3 or R06 type alkaline batteries. G Replace two batteries at the same time. G Do not use a new battery with a used battery. G Avoid contact with water or liquid. G Do not expose the remote control to moisture, or heat. G Do not drop the remote control. G If a battery has leaked on the remote control, carefully wipe case clean and install new batteries. G Risk of explosion if battery is replaced by an incorrect type. G Dispose of used batteries according to the instructions. Operating Range Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for the remote control is about 16.4' (5m) and 60° in front of the projector. 60° 16.4' (5 m) 14