Sanyo PLV Z1 Owners Manual - Page 35

Computer Input Computer Adjustment (Manual) This projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by MultiScan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture, or a skewed picture. This projector has a manual computer adjustment to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it. 1 Press the MENU button, and the main menu appears. Select the Computer Adjustment menu with the POINT UP/DOWN button, and then press the POINT RIGHT button to enter the sub-menu. Computer Adjustment menu Computer Adjustment menu 2 Choose the item that you want to adjust, and then press the POINT LEFT/RIGHT button to adjust the value. The Fine sync and Total dots are displayed in a line. Press the SELECT button after adjusting them. The on-screen menu returns to the submenu. Selected Mode Shows status (Stored/Free) of the selected mode. Press POINT LEFT/RIGHT button to adjust the value. Press the SELECT button at this icon to display other items. 3 To store the adjustment parameters, select the Store with the POINT UP/DOWN button and press the POINT RIGHT button. Reset To reset to previous level, select the Reset with the POINT UP/DOWN button and press the POINT RIGHT button. Select "Yes" with the SELECT button. Press the SELECT button at this icon to close the item. 35