Sanyo PLV Z1 Owners Manual - Page 31

Computer Input / (RGB Scart 21-Pin Video Input) Input Source Selection (Direct Operation) WARNING TEMP. READY INPUT BUTTON LAMP REPLACE You can select Computer input or Video input with the INPUT button. ON-OFF LAMP INPUT button (The input source that is selected last is selected when the projector is turned on.) Computer If the projector cannot reproduce proper image, select a correct input source through menu operation as shown below. Video RGB Scart Input TOP CONTROL When RGB Scart 21-pin output is available in video equipment, connect the Scart connector to the "COMPUTER IN" on the projector with an optionally supplied Scart-VGA cable. It can reproduce higher resolution and quality of picture. (See page 51 for order.) MENU INPUT To select RGB Scart input, follow the procedures described below. SELECT Note RGB Scart input (COMPUTER IN) can receive 575i only. REMOTE CONTROL INPUT IMAGE VIDEO IMAGE AUTO NO SHOW 1 VIDEO 2 INPUT button Input Source Selection (Menu Operation) 1 Press the MENU button, and the main menu appears. Select the Input Source Selection menu with the POINT UP/DOWN button, and then press the POINT RIGHT button to enter the sub-menu. Input Source Selection menu Input Source Selection menu 2 Choose the Computer with the POINT UP/DOWN button and press the POINT RIGHT button. The Source selection menu appears. Close the Input Source Selection menu. 3 Move the pointer to the source that you want to select with the POINT UP/DOWN button, and press the SELECT button. To select computer input, select the RGB. To select RGB Scart 21-pin video input, select the RGB (Scart). Close the source selection menu. *Select the RGB (Scart) only when connecting the projector with the Scart-VGA cable. Source Selection menu Close the source selection menu. 31